Installation of doors

It is known that repair process is time consuming and complicated, and requires a certain sequence and it must be considered before installing the interior doors. In most cases, to avoid damage, interior doors are installed at the end of repair. However, if repairs are carried out without leveling the floor and walls, doors can be delivered immediately.


Installation of door hardware is done by tapping the front strap locks, hinges and locking bolt in a box and a door leaf. For the upper loop allow the exclusion because depth of its frame is determined by the presence of backlash.

All fittings should be fitted to the cut-out jacks without gaps. No gap between the box and the card loop is a sign of excellence. Initially the card loops vremennno screwed to the end of the door leaf with two screws at a distance of approximately 20 cm from the top and bottom edges of the door.

The main thing is that the distance loops were identical in all doors. Further, the contour loop is encircled with a scalpel, screws unscrewed and remains the contour within which fetches the desired depth.

Once selections are made, and maps of the loops will be attached with screws on each of the loops put the rest of her half, and then applied box.

The position loop is noted at the reception, then the whole cycle of repeated inset maps, only this time with respect to the rack. Once the loops are embedded door leaf flips, crashes into the lock and inserted into the handle. For convenience and reduce the risk of damage to the cloth, striker plate crashes after installation of the door.